- 地址：
- 安國市南陽工業區
- 郵箱：
- 415130881@qq.com
- 電話：
- 18631165157
- 傳真：
- 0312-3427286
- 手機：
- 18631165157
渣漿泵的幾種常用結構形式單級或兩級單吸懸臂泵
一、 單級或兩級單吸懸臂泵
如圖2-13所示，這種結構泵用途最廣。泵軸的一端在托架內用軸承支承，另一端懸出，裝有葉輪，所以這種結構型式的泵常被稱為懸臂泵。軸承可以用稀油潤滑，也可以用油脂潤滑。軸封常采用填料或機械密封等，揚程低的泵可用骨架式橡膠密封。軸向力平衡常采用平衡孔或背葉片。圖2-13泵體為后開門的結構，裝拆時可不必拆卸進出口管路，但也可為前開門的結構，換葉輪時比較方便，只要把泵蓋拆下即可。為了增加泵的穩定性，底腳也可放到懸架上。單級揚程不能滿足時，可制成兩級泵，一般兩個葉輪采用背靠背排列以平衡軸向力。對高溫泵采用水平中心支承支架式的結構。渣漿泵廠家
Several common structure forms of slurry pump Single-stage or two-stage single suction Cantilever Pump
Single stage or two stage single suction Cantilever Pump
As shown in Figure 2-13, this kind of structure pump is most widely used. One end of the pump shaft is supported by a bearing in the bracket, and the other end is hung out with an impeller, so this type of pump is often called a cantilever pump. Bearings can be lubricated with thin oil or grease. The shaft seal usually adopts packing or mechanical seal, and the pump with low lift can be sealed with framework rubber. Balance hole or back blade is often used for axial force balance. Fig. 2-13 the pump body is of the structure of rear opening door. It is not necessary to dismantle the inlet and outlet pipelines during installation and disassembly, but it can also be of the structure of front opening door. It is convenient to change the impeller, as long as the pump cover is removed. In order to increase the stability of the pump, the foot can also be placed on the suspension. When the single-stage lift cannot be satisfied, two-stage pumps can be made. Generally, two impellers are arranged back-to-back to balance the axial force. The high temperature pump adopts the structure of horizontal center support bracket. Slurry pump manufacturer
